2011-2017 Coyote Crankshaft Position Sensor to Gen 3 Coyote Back Plate Adapter 6R80 swap It is required to have

It is required to have a regulator in the system since the 2011+ Coyote trucks have their regulator built into the fuel hat

Sick and tired of your 3

0 ECUs may require the use of 13-14 steering wheel buttons for cruise to work

0 Battery harness

Master Cylinder Mount also Silver Powder Coated

2011-2017 Coyote Crankshaft Position Sensor to Gen 3 Coyote Back Plate Adapter 6R80 swap It is required to haveThe Make It Modular is the crank shaft sensor adapter bushing that allows you to use the 11 17 Coyote Crankshaft Position Sensor in the Gen 3 Coyote ( 2018+) back plate. This means you don't have to swap the engine back plate to the 11 17 when doing a 3 2 1, 3 1 1, or similar setup where you want to use Gen 1 or Gen 2 management crank shaft sensor and are utilizing a Gen 3 short block. NOT COMPATIBLE WITH AFTERMARKET REAR PLATES Order yours today at